Diy laundry pedestal – A laundry column can be built to raise the height of a washer and dryer off the floor. This can keep you from having to bend over to put clothes in the washing machine and then bend over later to take them out and put them in the dryer.
Measure the width and depth of the washer or dryer. Transfer the measurements to a sheet of plywood for diy laundry pedestal. Cut out two pieces that are 3-1 / 2 square feet with the circular saw. These will be the top and bottom of the socket. Measure and cut two side pieces measuring 1-1 / 2 ft by 3-1 / 2 ft from the second piece of plywood. Measure and cut -and backing, measuring 1-1 / 2 ft by 3 ft 4-1 / 2 inches. Make a mark on the 4-urban 4 each 1-1 / 2 feet Cut marked with the circular saw. These will be the supports inside the socket.
12 Photos Gallery of: How to Build Diy Laundry Pedestal
Condition of the 1-1 / 2 by 3-1 / 2 ft pieces at their sides so that they are 3-1 / 2 ft apart. Put the two 1-1 / 2 to 3 ft 4-1 / 2-inch pieces in between the upper edges to form the shape of a box. Pre-drill four holes along each corner where the pieces meet. Drive four wood screws in each hole. Apply a strip of wood glue along the top edge, and then set one of the cut pieces of plywood on top. Drill a pilot hole every 6 inches along the edge of the frame diy laundry pedestal. Driving a wood screw into each hole.