Desk drawer pulls – Starting with one open door and turning the screws to remove existing drawer pulls, if necessary. Cut a fabric strip 3 inches by 20 inches for each tray moves. Lay the fabric strips the wrong side of the ironing board. Fold over one inch along a long side of each fabric, wrong sides together, and press your iron. Fold over 1 inch along the other long side of each fabric, wrong sides together, and press your iron.
Fold raw edge of the top flap of fabric of each strip in face pressure, and pressure with your iron. Lift the fabric fold and run a thin line glue the bottom edge folded fabric in the center of the back of the desk drawer pulls. Press the fabric with your hands and let the glue dry. Fold the ends of each strip in half and then in half again, rolling them between thumb and forefinger compress. Wrap a piece of tape tightly around each end.
12 Photos Gallery of: To Get the Fabric Desk Drawer Pulls
Press a tape covered end of a fabric tray moves through a screw hole in the tray. And the second band covers the end of the same fabric tray three other screw whole which draws. Insert empty toilet roll tube between the tray and the fabric. And then pull the fabric taut without crushing the tube. Tying the ends of the fabric tray features together in a knot in the tray. The fabric desk drawer pulls was done.Incoming search terms: desk drawer pulls, fabric pulls